2008 Honda Accord

Front Headlamp has a product on the lens but not seriously reducing light output Both side (4.1.4 (b))

Nearside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement upper suspension part (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement Both side (5.3.4 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Front Headlamp has a product on the lens but not seriously reducing light output Both side (4.1.4 (b))

Nearside Rear Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement upper suspension part (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement Both side (5.3.4 (a) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength INNER AND OUTER SILL LOWER WHEEL ARCH (5.3.6 (a) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Suspension component mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected CENTRE FLOOR (5.3.6 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Front Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D-Bush (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin both sides (1.1.13 (a) (ii))

Rear Exhaust mounting defective rear/central box mounting (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Parking (secondary brake) grabbing slightly (1.3.1 (c))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Service brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

eml on

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Obligatory mirror damaged, but not seriously affecting the rear view (8.1.2a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

eml on

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)