2008 Citroen Relay

Brake pipe corroded, covered in grease or other material various pipes (1.1.11 (c))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Suspension component mounting prescribed area is corroded but not considered excessive front and back and inner and outer sills and floor area both sides (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Brake pipe corroded, covered in grease or other material various pipes (1.1.11 (c))

Nearside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Suspension component mounting prescribed area is corroded but not considered excessive front and back and inner and outer sills and floor area both sides (5.3.6 (a) (i))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Suspension arm pin or bush worn but not resulting in excessive movement both front arms (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Suspension arm pin or bush worn but not resulting in excessive movement both front arms (5.3.4 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive front and back (5.3.6 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

n/s/f inner wing damp with fliud

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Parking brake: efficiency below requirements (3.7.B.7)

rear parking brake recording little or no effort (3.7.B.6a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Towbar component fractured (6.6.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust system not adequately supported (7.1.1)

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Wheel stud(s) missing (4.2.A.1e)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.C.1d)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)