MOT Status
ExpiredMileage
60,895 miSignificantly above average — investigate
Not all car check providers offer a guarantee. Don't risk buying from services that can't back their data. CarVerify reports include a £30,000 finance data guarantee.
Vehicle Details
All premium checks include
50+ data pointsMOT History
lots of welding done on floor corroded around petrol cap
Front Windscreen washer not working (3.5 (a))
Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))
Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))
Offside Front Upper Macpherson strut top bush or bearing has excessive wear or free play (5.3.4 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))
Oil leak, but not excessive (8.4.1 (a) (i))
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))
Suspension component mounting repair covered in underseal (5.3.6 (a) (i))
Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))
Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced sill to floor (7.1.1 (a) (i))
Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))
Offside Front Suspension arm pin or bush excessively worn rear mounting bush (5.3.4 (a) (i))
Offside Rear Suspension component mounting prescribed area is inadequately repaired under wheel arch holed (5.3.6 (a) (i))
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor (7.1.1 (a) (i))
Offside Seat belt anchorage prescribed area strength or continuity significantly reduced middle section outer sill (7.1.1 (a) (i))
Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS
Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))
Suspension component mounting prescribed area is corroded but not considered excessive underbody (5.3.6 (a) (i))
Nearside Rear Outer Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))
Offside Front Lower Suspension arm pin or bush excessively worn rear (5.3.4 (a) (i))
Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end (5.3.6 (a) (i))
Nearside Rear Inner Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))
Offside Rear Inner Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))
Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Oil leak, but not excessive (8.4.1 (a) (i))
Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))
Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))
Oil leak, but not excessive (8.4.1 (a) (i))
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Rear registration plate deteriorated but not likely to be misread (6.3.1d)
Offside Front coil spring broken (2.4.C.1a)
Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)
Rear registration plate deteriorated but not likely to be misread (6.3.1d)
exhaust slightly deteriortaed
Brake fluid warning lamp illuminated (3.6.G.2)
Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)
Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Nearside Headlamp not working on dipped beam (1.7.5a)
Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)
Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)
Nearside Front Road wheel slightly damaged (4.2.A.1a)
exhaust slightly deteriortaed
rear tyres slightly deteriorated
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
o/s & n/s rear tyres slightly deteriorated/small cuts/cracks
Brake fluid warning lamp illuminated (3.6.G.2)
Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)
Front Brake pad(s) less than 1.5 mm thick (3.5.1g)
Nearside Stop lamp not working (1.2.1b)
Nearside Windscreen washer provides insufficient washer liquid (8.2.3)
Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)
Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)
Offside Headlamp not working on dipped beam (1.7.5a)
Offside Windscreen washer provides insufficient washer liquid (8.2.3)
Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)
Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
o/s & n/s rear tyres slightly deteriorated/small cuts/cracks
Nearside Front Tyre worn close to the legal limit (4.1.E.1)
How Reliable is the Ford Ka?
Based on 8,818,307 MOT tests across 675,715 vehicles.
Top MOT Failure Points
Don't risk it. Know before you buy.
Not all vehicle check providers are the same. Some don't offer a data guarantee, which means if their information is wrong, you're on your own. Every CarVerify report is backed by a £30,000 finance data guarantee.
OV08 LLF is a 2008 Ford Ka in Silver with a 1,299cc petrol engine. This vehicle has been through 18 MOT tests with a personal pass rate of 61.1%.
Across all 2008 Ford Ka models, the average MOT pass rate is 71.0% with a typical mileage of 41,756 miles. This particular vehicle has a lower pass rate than the average for its year, which may indicate maintenance issues worth investigating.
The most common reason a Ford Ka fails its MOT is suspension component mounting prescribed area is excessively corroded, accounting for 404,005 recorded failures. If you're considering buying OV08 LLF, it's worth having these areas checked by a mechanic before committing.
The Ford Ka typically stays on UK roads for around 29 years. At 18 years old, this Ford Ka is well into its expected lifespan but still has years ahead.
Frequently Asked Questions
How do I check the history of OV08 LLF?
You can check the full history of OV08 LLF by running a full vehicle check. This shows you finance, stolen, write-off, MOT history, mileage records and more.
What year was OV08 LLF registered?
OV08 LLF is a 2008 Ford Ka, first registered on 21 April 2008.
Is OV08 LLF safe to buy?
The MOT history for OV08 LLF shows 18 tests with a 61.1% pass rate. To check for outstanding finance, stolen markers, write-off history and mileage discrepancies, run a full vehicle check.
Does OV08 LLF have outstanding finance?
Finance checks require a premium vehicle report. This checks against all major UK finance providers to see if there is any outstanding finance on OV08 LLF. If you buy a car with outstanding finance, the finance company can repossess it.
No warranty or guarantee of accuracy is provided for any free data on this page. The data guarantee applies only to information obtained through the purchase of a full check.