2003 Peugeot 406

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Suspension rod pin or bush worn but not resulting in excessive movement tie bar (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Suspension rod pin or bush worn but not resulting in excessive movement tie bar (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint plus boot split (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

o/s front top suspension bearing/mounting sticking. clutch pedal high

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim too high (1.8)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too high (1.8)

Offside Rear Body has a sharp edge caused by damage (6.1.C.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering pipe(s) or hose(s) leaking from a seal (2.3.3b)

Rear Brake performance not tested (3.7.A.1)

Registration plate lamp not illuminating the registration plate (1.1.C.1e)

o/s front top suspension bearing/mounting sticking. clutch pedal high

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Headlamp aim too high (1.8)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

small chip in winsc reen. front brake discs in poor condition. n/s front anti roll bar link worn and knocking. o/s front road spring corroded.

Headlamp switch faulty (1.7.1)

Nearside Direction indicator not working (1.4.A.2c)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Seat belt affected by an insecure seat fixing (5.2.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Suspension arm has excessive play in a pin/bush (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering pipe(s) or hose(s) leaking from a joint (2.3.3b)

small chip in winsc reen. front brake discs in poor condition. n/s front anti roll bar link worn and knocking. o/s front road spring corroded.

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Oil leak

Tyres feathering slightly.

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front position lamp(s) not working (1.1.A.3b)

Parking brake: efficiency below requirements (3.7.B.7)

Front Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Handbrake travel.

Nearside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Oil leak

Tyres feathering slightly.

Wipers streak and judder.

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)