2008 Ford Ka

surface corrosion o/s n/s inner sills,inner rear sills,front,rear chassis,rear axle mounts,front subframe mounts,inner front arches,front floors,o/s/f seat mount,o/s outer sill,fuel filter

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Lower Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Headlamp aim too low (4.1.2 (a))

surface corrosion o/s n/s inner sills,inner rear sills,front,rear chassis,rear axle mounts,front subframe mounts,inner front arches,front floors,o/s/f seat mount,o/s outer sill,fuel filter

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement n/s and o/s lower arm rear bush (2.4.G.2)

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement n/s and o/s lower arm rear bush (2.4.G.2)

Front Windscreen wiper blade insecure (8.2.2)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Rear position lamp(s) not working (1.1.A.3b)

Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

rear tyres perished

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim too high (1.8)