2008 Fiat Scudo

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake disc worn, but not excessively Both Front Brake Disks (1.1.14 (a) (i))

Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt Both Steering Gaiters (2.1.3 (g) (i))

Nearside Front Inner Play in steering rack inner joint(s) ()

Integral body structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Position lamp slightly affected by the operation of another lamp (4.2.3 (c))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced Both Rear Sides (6.1.1 (c) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outrigger holed (5.3.6 (a) (i))

Suspension component mounting prescribed area is corroded but not considered excessive both rear floor pan lips rusting close to coil spings (5.3.6 (a) (i))

Brake pedal anti-slip provision missing (1.1.2 (c))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Outer Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill holed (5.3.6 (a) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Registration plate insecure but not likely to fall off (0.1 (a))

Nearside Front Lower mirror glass cracked

Suspension component mounting prescribed area is corroded but not considered excessive both rear floor pan lips rusting close to coil spings (5.3.6 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Emissions not tested Despite cleaning smoke meter optical the vehicle had excess metered smoke, contaminating optical lens; tested 3 times (8.2.2.2 (e))

Power steering component leaking Steering rack and or pipe work (2.1.5 (a))

Power steering fluid reservoir empty (2.1.5 (b) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Brake lever has insufficient reserve travel (1.1.2 (a))

Emissions not tested (8.2.2.2 (e))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Brake cable has restricted free movement (1.1.15 (e))

Windscreen washer not working (3.5 (a))

Exhaust emits excessive smoke or vapour likely to obscure the vision of other road users (8.2.2.2 (c)) DANGEROUS

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake pad(s) wearing thin (3.5.1g)

Central Stop lamp not working (1.2.1b)

Emissions not tested low oil level (7.3.A.1)

Nearside Front Steering rack gaiter split (2.2.D.2d)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Oil leak major ()

engine mill light on

engine oil leak

Centre Stop lamp not working (1.2.1b)

Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

engine mill light on

engine oil leak

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Oil leak

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim too high (1.8)

Nearside Stop lamp not working (1.2.1b)

Offside Front position lamp(s) not working (1.1.A.3b)

Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Headlamp aim too low (1.8)