2007 Jaguar Xj

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Fuel tank insecure (6.1.3 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Windscreen washer not working (3.5 (a))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front unable to spin to check bearing due to binding

Offside main bam bulb insecure

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Direction indicator slightly discoloured (4.4.3 (a))

Rear Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Offside Rear Lower Shock absorbers has an excessively worn bush (5.3.2 (c))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Rear Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Exhaust fumes entering cabin (6.1.2 (b) (i))

Nearside Rear Brake pipe excessively corroded up and over axle area (1.1.11 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Windscreen wiper does not clear the windscreen effectively both (3.4 (b) (ii))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Upper Suspension arm pin or bush worn but not resulting in excessive movement Inner bushes. (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material Rigid brake pipes corroding on the back - From the nearside across to the offside. Around the filler neck. (1.1.11 (c))

Offside Rear Lower Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Front Lower Suspension component pin or bush slightly worn shock bush has slight play. (5.3.4 (a) (i))

Nearside Rear Inner Suspension component pin or bush slightly worn Upper wishbone has slight play. (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Lower Shock absorber has a slightly worn bush (2.7.4)

Offside Front Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front Lower Shock absorber has a slightly worn bush (2.7.4)