2001 BMW Z3

Front Sub-frame is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Brake disc worn, pitted or scored, but not seriously weakened both (1.1.14 (a) (ii))

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

EML on

center exhaust mount missing

o/s/f lollipop bush starting to seperate

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Direction indicator incorrect colour (1.4.A.2f)

Nearside Side repeater incorrect colour (1.4.A.2f)

Offside Side repeater incorrect colour (1.4.A.2f)

EML on

center exhaust mount missing

o/s/f lollipop bush starting to seperate

Nearside Lower Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Lower Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

fuel cap seal deteriorated

Brakes imbalanced across an axle (3.7.B.5b)

Front Exhaust system not adequately supported (7.1.1)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

fuel cap seal deteriorated

Brake discs corroded.

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Side repeater slightly discoloured (1.4.A.2f)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Rear brake disc slightly pitted (3.5.1h)