2005 Mazda 6

Engine covers fitted obscuring some components in the engine bay

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Under-trays fitted obscuring some underside components

Nearside Front front brake binding (3.7.B.1)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Nearside Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Anti-roll bar corroded but not seriously weakened (2.4.G.1)

Under-trays fitted obscuring some underside components

off side rear tyre has cut to inside wall but ok

slight bind off side rear brake

Nearside Front front brake binding (3.7.B.1)

Nearside Rear Stop lamp emits other than a steady red light (1.2.1e)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

engine oil level is low

front brake disc's are rust lipped on inner edges

Exhaust has part of the system slightly deteriorated (7.1.1a)

both rear tyre's are cracking on inner sidewalls

front disc's a small rusty lips on inner edge

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Exhaust has part of the system slightly deteriorated (7.1.1a)

both rear tyre's are cracking on inner sidewalls

front disc's a small rusty lips on inner edge

n/s/f brake reading lower than o/s.

n/s/r tyre at legal limits.

surface cuts to o/s/r tyre inner shoulder.

unable to inspect brake pads.