1997 Honda Civic

Exhaust has a minor leak of exhaust gases SMALL LEAK BY CAT (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement BUSH CORRODED AND SHOWING SIGNS OF WEAR, NO MOVEMENT PRESENT (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement BUSH CORRODED AND SHOWING SIGNS OF WEAR, NO MOVEMENT PRESENT (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Exhaust has a minor leak of exhaust gases SMALL LEAK BY CAT (6.1.2 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement BUSH CORRODED AND SHOWING SIGNS OF WEAR, NO MOVEMENT PRESENT (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement BUSH CORRODED AND SHOWING SIGNS OF WEAR, NO MOVEMENT PRESENT (5.3.4 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Power steering component has slight seepage from a component shaft (2.1.5 (a))

Exhaust emissions likely to be affected by an exhaust leak on catalyst (8.2.1.1 (b))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill area (5.3.6 (a) (i))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Offside Front Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill area (5.3.6 (a) (i))

Coil spring corroded all four (5.3.1 (b) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Brake pipe clips or supports missing, pipe adequately supported all (1.1.11 (d) (i))

Exhaust has a minor leak of exhaust gases front pipe (cat) (6.1.2 (a))

Fuel Pipe/s corroded all ()

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement axle bush (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement axle bush (5.3.4 (a) (i))

Power steering component has slight seepage from a component steering rack n/s (2.1.5 (a))

Both rear brake pipes have slight corrosion

Headlamp Lenses

Nearside Front Foglight inoperative

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm bush (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement Trailing arm bush (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced floor pan (6.1.1 (c) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced floor pan (6.1.1 (c) (i))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm bush (5.3.4 (a) (i))

Nearside Front Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Inner Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Tyre worn close to legal limit/worn on edge edge (5.2.3 (e))

slight damage on front number plate

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing slightly noisy (5.1.3 (b) (i))

slight noise from o/s /r wheel bearing

Nearside Front Suspension component mounting prescribed area is excessively corroded floor (2.4.A.3)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Steering rack gaiter split (2.2.D.2d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside rear brake binding (3.7.B.1)

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Rear Direction indicator incorrect colour (1.4.A.2f)

Offside rear brake binding (3.7.B.1)

Nearside Vehicle structure has slight corrosion (6.1.B.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Vehicle structure has slight corrosion (6.1.B.2)

Rear Direction indicators slightly discoloured (1.4.A.2f)

Nearside Front Headlamp aim too low and too far to the left. (1.8)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

rear indicators faded

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

rear indicators faded

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)