1997 Mercedes-benz 308 D

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Prop shaft bearing has slight play (6.1.7 (b) (i))

All direction indicators slightly discoloured (4.4.3 (a))

Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Exhaust silencer likely to become detached (8.1.1 (b) (ii)) DANGEROUS

All direction indicators slightly discoloured (4.4.3 (a))

Hazard warning switch insecure (4.4.2 (a) (i))

exhaust tail pipe missing

Anti-roll bar rubber bush deteriorated but not resulting in excessive movement all front (2.4.G.2)

Rear position lamp(s) has light sources not illuminating, but not more than 50% both rear (1.1.A.3b)

both front arches and steps corroded

vehicles ignition does not stop engine

Nearside Rear Suspension spring mounting prescribed area is excessively corroded rear mount (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded rear mount (2.4.A.3)

Parking brake: efficiency below requirements (3.7.B.7)

Anti-roll bar rubber bush deteriorated but not resulting in excessive movement all front (2.4.G.2)

Rear position lamp(s) has light sources not illuminating, but not more than 50% both rear (1.1.A.3b)

both front arches and steps corroded

exhaust tail pipe missing

vehicles ignition does not stop engine

Front passenger door does not latch securely closed (6.2.B.1a)

Headlamp aim not tested (1.8.A.1c)

Nearside Headlamp adversely affected by the operation of another lamp (1.7.5c)

Nearside Obligatory mirror insecure (8.1.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded shock mount and under bump stop (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded shock mount (2.4.A.3)

Offside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear registration plate deteriorated (6.3.1d)

Service brake: efficiency below requirements (3.7.B.7)

Suspension spring mounting prescribed area is excessively corroded both rear spring mounts cross member (2.4.A.3)

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement all front (2.4.G.2)

Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement all rear (2.4.G.2)

Driver's door hinge deteriorated but the door can still be readily opened and closed (6.2.B.2)

Offside Front wheel arch corroded

exhaust tail pipe missing

vehicle ignition does not stop engine

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front step corroded

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

exhaust tip missing

Fuel pipe leaking (7.2.3)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brakes imbalanced across an axle (3.7.B.5b)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front step corroded

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

exhaust tip missing

Nearside Front Lower Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Parking brake only just meets minimum requirement

Fuel pipe leaking (7.2.3)

Nearside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front brake disc in such a condition that it is seriously weakened (3.5.1i)

Offside Obligatory mirror seriously damaged, affecting the rear view (8.1.2a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Front Lower Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Anti-roll bar linkage rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

front brake discs in poor condition

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

front brake discs in poor condition

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

front discs poor condition

o/r sidelight 1 x inop.

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

front discs poor condition

o/r sidelight 1 x inop.

Fuel pipe leaking (7.2.3)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Headlamp not working on main beam (1.7.5a)

Offside Rear Stop lamp not working (1.2.1b)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nail in nearside front tyre

Nearside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Seat belt damaged sufficient to obstruct correct operation of the belt (5.2.2a)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Anti-roll bar rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Registration plate lamp not working (1.1.5c)

Service brake: efficiency below requirements (3.7.B.7)

Nail in nearside front tyre

Nearside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nail in offside front tyre

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Offside Headlamp not working on dipped beam (1.7.5a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Offside Front Seat belt damaged but not affecting the operation of the belt (5.2.2a)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)