1996 Rover 114

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner and outer sill (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced centre floor (7.1.1 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

corrosion rear cross member

nearside front lower arm corroded

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake pad(s) wearing thin both (1.1.13 (a) (ii))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Parking brake lever has excessive movement indicating incorrect adjustment (1.1.6 (c))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Underbody corrosion rear

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Underbody corrosion rear

Rear inner panel holed but not structual

Rear seat belt buckles under seat

possible corrosion on outer sills

Fuel Pipe/s corroded ()

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

exhaust deteriorated

front hbs corroded

plastic sill covers fitted

vehicle has been stood

Exhaust has a major leak of exhaust gases (7.1.2)

Offside rear brake recording little or no effort (3.7.B.5a)

vehicle has been stood

Fuel Pipe/s corroded ()

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

exhaust deteriorated

front hbs corroded

plastic sill covers fitted

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Lower Suspension arm corroded and seriously weakened (2.4.G.1)

Nearside Rear Lower Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Lower Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Direction indicator slightly discoloured (1.4.A.2f)

suspension low