1997 Mazda MX-5

Front Registration plate does not conform to the specified requirements (0.1 (d))

Front Registration plate insecure (0.1 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Body component damaged and likely to cause injury outer wheel arch sharp edge (6.2.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner wheel arch area (7.1.1 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill area (5.3.6 (a) (i))

Offside Seat belt anchorage prescribed area strength or continuity significantly reduced floor pan (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Exhaust has a major leak of exhaust gases (6.1.2 (a))

Rear Exhaust system insecure silencer mount (6.1.2 (a))

Side repeater not working o/s and n/s (4.4.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Nearside Non obligatory mirror damaged ()

Nearside Rear Suspension component mounting prescribed area damaged but not considered excessive outer sill area (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Position lamp slightly affected by the operation of another lamp both rear (4.2.3 (c))

Tyre worn close to legal limit/worn on edge both rear (5.2.3 (e))

hole in o/s/f lower wing

Offside Rear Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sill also around drain hole. (6.2.2 (d) (i))

Emissions not tested (8.2.1.2 (d))

Nearside Front Outer Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Upper Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Offside Rear Outer Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security Sill also around drain hole. (6.2.2 (d) (i))

Rear Brake pad(s) wearing thin Both (1.1.13 (a) (ii))

Rear Exhaust mounting defective rubber ring missing (6.1.2 (a))

Offside Front Outer Brake pipe corroded, covered in grease or other material Near flexible (1.1.11 (c))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Outer Brake pipe corroded, covered in grease or other material Near flexible (1.1.11 (c))

Nearside Headlamp incorrect colour (4.1.4 (a))

Offside Headlamp incorrect colour (4.1.4 (a))

Rear fog lamp not working (4.5.1 (a) (ii))

Headlamp has a product on the light source but not seriously reducing light output both (1.7.5a)

Nearside Front Inner Subframe mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Offside Front Inner Subframe mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Offside Front Lower Shock absorber has a slightly worn shock absorber pivot (2.7.4)

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Headlamp has a product on the light source but not seriously reducing light output both (1.7.5a)

Headlamp incorrect colour both (1.7.5b)

Nearside Front Inner Subframe mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Offside Front Inner Subframe mounting prescribed area is distorted but not considered excessive (2.4.A.3)

Offside Front Lower Shock absorber has a slightly worn shock absorber pivot (2.7.4)

rear parking (secondary) brake imbalance requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.6b)

Offside Headlamp aim too high (1.8)

Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

nearside and offside chassis member have damage on them

nearside and offside front tyre outer sidewalls starting to crack