1996 Mazda Bongo

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Rear Position lamp not working (4.2.1 (a))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced cross member (6.1.1 (c) (i))

Offside Inner Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced sill (6.1.1 (c) (i))

Nearside Front Outer Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Offside Front Outer Seat belt anchorage prescribed area is excessively corroded sill (5.2.6)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Outer Vehicle structure has slight corrosion sill (6.1.B.2)

Offside Outer Vehicle structure has slight corrosion sill (6.1.B.2)

Brake pipe slightly corroded (3.6.B.2c)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings x member (6.1.B.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings x member (6.1.B.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Brake pipe slightly corroded (3.6.B.2c)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Rear Rear fog lamp not working (1.3.2b)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Registration plate lamp not working (1.1.5c)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.5c)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear Rear fog lamp not working (1.3.2b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

limited reserve travel on the handbrake

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)