2007 Ford Freda

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive cross member (5.3.6 (a) (i))

Nearside Front Suspension component mounting repair covered in underseal inner sill /step (5.3.6 (a) (i))

Nearside Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive inner sill (5.3.6 (a) (i))

Offside Front Suspension component mounting repair covered in underseal wheel arch rear of wheel (5.3.6 (a) (i))

Offside Rear Suspension component mounting repair covered in underseal inner sill (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive outer sill (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive crossmember (5.3.6 (a) (i))

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive inner wheel arch/sill back (2.4.A.3)

Rear Subframe mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Central Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Front Subframe mounting prescribed area is excessively corroded outrigger (2.4.A.3)

Nearside Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Offside Front Subframe mounting prescribed area is excessively corroded outrigger (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded inner sill (5.2.6)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive inner wheel arch/sill back (2.4.A.3)

Rear Subframe mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Lower Body has slight corrosion (6.1.B.2)

Nearside Front Lower Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Anti-roll bar has excessive play in a pin/bush (2.4.G.2)

Offside Stop lamp not working (1.2.1b)

Service brake: efficiency below requirements (3.7.C.1a) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

o/s/r hub seal slight leak

rerar brakes slight bind

Oil leak

n/s/r o/s/r tyres cracking up

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Horn not working (1.6.2a)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)