2006 Mazda Bongo

Exhaust has a major leak of exhaust gases front pipe (6.1.2 (a))

Nearside Front Upper Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Windscreen washer not working (3.5 (a))

Nearside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Offside Front Lower Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Windscreen washer not working (3.5 (a))

Offside Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both rear (5.3.4 (a) (i))

Brake disc worn, pitted or scored, but not seriously weakened both rear inner faces have a reduced braking surface (1.1.14 (a) (ii))

Oil leak, but not excessive both half shaft seals(rear brake back plates oily) (8.4.1 (a) (i))

Power steering component has slight seepage from a component steering rack pinion oil seal inner offside sill(rack oily) (2.1.5 (a))

both outer sills have corossion in panels in non prescribed areas,inner offside sill/floor corodded

Corrosion to N/S Outer sill

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Parking brake lever has little reserve travel (3.1.6b)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Outer Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings centre sill, door pillar (6.1.B.2)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Rear Outer Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Offside Outer centre sill

brake disc worn, pitted or scored, but not seriously weakened all disc's pitted (3.5.1i)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Headlamp deteriorated but light output not reduced (1.7.5a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Lower Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Rear fog lamp not working (1.3.2b)

front brake discs slightly worn

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)