1996 Ford Ka

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Nearside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Lower Seat belt anchorage prescribed area is inadequately repaired (5.2.6)

Offside Front Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Rear Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Power steering fluid level below minimum (2.3.1)

Oil leak

Power steering pipe(s) or hose(s) has slight seepage from a joint (2.3.3b)

both sides floor pan areas damaged

o/s headlamp condensated

o/s/r chassis leg corroded near axle mounting

o/s/r chassis leg repair poor/covered,difficult to assess

power steering noisy

power steering pipe touching exhaust

rear registration plate is not fully secure

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Brake hose stretched (3.6.B.4c)

Offside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Battery insecure

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

corrosion to inner and outer sill

Nearside Headlamp aim too low (1.8)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Headlamp aim too low (1.8)

Battery insecure

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

corrosion to inner and outer sill

n/s/r tyre on limit,corrosion to suspension mounts/components,sills/floorpans

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Headlamp aim too high (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

n/s/r tyre on limit,corrosion to suspension mounts/components,sills/floorpans

Brake hose slightly deteriorated (3.6.B.4d)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Oil leak

Brake hose slightly deteriorated (3.6.B.4d)

Nearside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

temporary fuel cap fitted