1997 Mazda MX-5

nail n/s rear tyre

Parking brake efficiency below requirements (1.4.2 (a) (i))

nail n/s rear tyre

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Position lamp adversely affected by the operation of another lamp flashing (4.2.3 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

front and rear suspension parts and subframes corroded

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Offside Vehicle structure is deformed but structural rigidity is not significantly reduced (6.1.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced inner/floor area (7.1.1 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill/floor area (7.1.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Upper Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Rear wheel arch area by seat belt mounting

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Vehicle structure is deformed but structural rigidity is not significantly reduced floor/chassis rail (6.1.1 (a) (i))

Emissions not tested (8.2.1.2 (d))

Headlamp aim projected beam image is obviously incorrect both (4.1.2 (c))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Offside Front Headlamp light intensity severely reduced (4.1.4 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Suspension arm corroded but not seriously weakened n/s and o/s upper arms (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened and under sealed (5.3.3 (b) (i))

Rear Suspension arm corroded but not seriously weakened n/s and o/s upper arms (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced n/s and o/s under arches and sills fully under sealed not allowing full inspection (6.1.1 (c) (i))

Nearside Front Tyre worn close to the legal limit wearing on inside (4.1.E.1)

Offside Front Tyre worn close to the legal limit wearing on inside (4.1.E.1)

corroded o/s rear not within 300

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Seat belt anchorage prescribed area is excessively corroded centre (5.2.6)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre worn close to the legal limit wearing on inside (4.1.E.1)

Offside Front Tyre worn close to the legal limit wearing on inside (4.1.E.1)

corroded o/s rear not within 300

Brake pipe slightly corroded all where visible. (3.6.B.2c)

Offside Rear inner arch has hole due to corrosion not within any prescribed areas.

Vehicle structure has slight corrosion all areas. (6.1.A.1)

all suspension components have surface corrosion.

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear coil spring broken (2.4.C.1a)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Vehicle structure has slight corrosion (6.1.A.1)

all front and rear suspension components have thick layer of surface corrosion.

both rear inner wheelarches rusting

off side rear outer sill rusted

Suspension joint nearside upper dust cover split/missing

Suspension joint offside upper dust cover split/missing

o/s/r/ cill corroded.

Brakes imbalanced across an axle (3.7.B.5b)

Centre Horn not working (1.6.2a)

Offside Front Headlamp aim too low (1.8)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Offside Rear coil spring fractured (2.4.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Suspension joint nearside upper dust cover split/missing

Suspension joint offside upper dust cover split/missing

Rear Brake pad(s) wearing thin (3.5.1g)

front brake juddering slightly (3.7.A.2b)

Horn not working (1.6.2a)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

front brake juddering slightly (3.7.A.2b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear coil spring corroded (2.4.C.1b)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear coil spring corroded (2.4.C.1b)

hand brake travel

under body rust