2007 Mazda Bongo

Oil leak, but not excessive (8.4.1 (a) (i))

Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced inner arch (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outter sill (5.3.6 (a) (i))

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting behind bumper (6.1.6 (i) (i))

Nearside Rear Registration plate lamp missing in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component steering rack (2.1.5 (a))

Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced rear out rigger behind bumper (7.1.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis leg (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end (5.3.6 (a) (i))

Rear Stop lamp(s) all not working (4.3.1 (a) (iii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Power steering component has slight seepage from a component steering rack (2.1.5 (a))

Rear Oil leak, but not excessive engine (8.4.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Rear Coolant leak heater pipe ()

Rear Oil leak, but not excessive engine (8.4.1 (a) (i))

Nearside Front Subframe mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wing (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength outer sill (5.3.6 (a) (i))

Nearside Rear Towbar excessively corroded within 30cm of towbar mounting crossmember (6.1.6 (i) (i))

Offside Front Anti-roll bar pin or bush excessively worn D bush (5.3.4 (a) (i))

Offside Rear Anti-roll bar linkage pin or bush excessively worn (5.3.4 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced wheel arch liner to chassis (7.1.1 (a) (i))

Offside Rear Towbar excessively corroded within 30cm of towbar mounting lower wing/crossmember area (6.1.6 (i) (i))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Oil leak engine ()

Nearside Rear Tyre has a lump, caused by separation or partial failure of its structure tread area out of shape (4.1.D.1b)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Anti-roll bar rubber bush deteriorated resulting in excessive movement D bush (2.4.G.2)

Offside Front Subframe mounting prescribed area is excessively corroded outrigger (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is excessively corroded lower wing area (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner sill and floor to inner sill (2.4.A.3)

Power steering component(s) leaking pump (2.3.3b)

rear parking (secondary) brakes imbalanced (3.7.B.6b)

Offside Rear tyre out of shape and tread low

Oil leak engine ()

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Fuel system component leaking fuel pump (7.2.3)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded lower wing area (5.2.6)

Offside Front Subframe mounting prescribed area is excessively corroded crossmember (2.4.A.3)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Front Headlamp aim too low (1.8)

Front Windscreen wiper blade insecure (8.2.2)

Nearside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Lower Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Shock absorber has a light misting of oil (2.7.3)

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Anti-roll bar attachment bracket/mounting bolt missing (2.4.G.1)

Offside Rear Stop lamp not working (1.2.1b)