1996 Honda XR400

Presented for test with headlight lens masked - to flatten beam image in headlight tester. Not fitted with indicators or rear footrests - not required. Fitted with road legal - off road type tyres. Unable to obtain stable brake test readings.

Stop lamp does not illuminate by the operation of both brake controls front stop light switch does not function (4.3.2 (a) (iii))

Horn not working (7.7 (a) (ii))

Position lamp not working (4.2.1 (a))

Front Brake disc significantly and obviously worn front brake disc worn below limit (1.1.14 (a) (i))

Front Brake hose excessively chafed front brake hose chafed though on outer casing (1.1.12 (b) (ii))

Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Headlamp aim too low (4.1.2 (a))

Horn not working (7.7 (a) (ii))

Position lamp switch does not illuminate all position lamps with a single operation front position lamp does not come on with the rear one (4.2.2 (a))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate lamp missing in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Shock absorber has an excessively worn bush top and bottom shock bushes worn (5.3.2 (c))

Steering operation linkage fouling when handlebars turned from lock to lock fouling on headlight (2.1.4 (a))

Throttle operating incorrectly throttle does not return correctly (6.2.7 (a) (i))

Rear Brake caliper inadequately mounted and braking performance affected rear brake caliper not in mounting slot (1.1.16 (c) (ii)) DANGEROUS

Rear Brake disc in such a condition that it is seriously weakened rear brake disc scored and worn due to rear pads being worn out (1.1.14 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Fuel tank slightly loose rear strap missing (6.1.3 (a) (i))

Riders seat slightly loose not clipped under at front (6.2.5 (a) (ii))

Headlamp aim too low (4.1.2 (a))

Registration plate does not conform to the specified requirements (0.1 (d))

Exhaust noisy (7.1.2)

Rear Wheel spoke slightly loose. (4.2.1b)

Wheel alignment slightly misaligned. (2.5.1)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Tyre is unsuitable (4.1.1)

Front wheel bearings have excessive free play (2.3.5b)

Horn not working (1.7.3a)

Exhaust noisy (7.1.2)

Lower Rear mono-shock pivot worn but not excessive (2.4.B.4)

Rear Wheel spoke slightly loose. (4.2.1b)

Wheel alignment slightly misaligned. (2.5.1)

Rear Wheel spoke slightly loose. (4.2.1b)

number plate lamp inop

Headlamp aim beam image kick up to the offside (1.6)

Horn not working (1.7.3a)

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Brake pedal attachment screws missing. (3.1.2b) DANGEROUS

number plate lamp inop

Exhaust noisy (7.1.2)