1996 Mitsubishi Lancer

Brake pedal slightly spongy

Centre Rear Seat belt damaged sufficient to significantly weakened the webbing (5.2.2a)

Exhaust catalytic converter missing where one was fitted as standard (7.1.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Horn not working (1.6.2a)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Lower Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Upper Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Rear Upper Suspension arm fractured (2.4.G.1)

corrosion developing within 30cm of o/s and n/s rear sus sub frame mounting points

Offside Rear Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front registration plate margin less than the minimum requirement (6.3.4g)

Horn not working (1.6.2a)

Offside Rear fog lamp not working (1.3.2b)

Offside Rear Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear wheel bearing has slight play (2.6.2)

Nearside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear wheel bearing has slight play (2.6.2)

Nearside Inner Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Inner Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)