1997 Mazda Bongo

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Front Lower Suspension arm corroded and seriously weakened (5.3.3 (b) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Coolant leak ()

Nearside Headlamp aim too low (1.8)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Nearside Stop lamp not working (1.2.1b)

Rear Anti-roll bar has excessive play in a pin/bush both (2.4.G.2)

Coolant leak ()

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emits an excessive level of metered smoke for a turbo charged engine (7.4.B.3b)

Nearside Front Subframe mounting prescribed area is excessively corroded underwing in multiple places (2.4.A.3)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded underwing (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Offside Front Subframe mounting prescribed area is excessively corroded underwing in multiple places (2.4.A.3)

Offside Front front brake excessively fluctuating (3.7.B.3)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Suspension component mounting prescribed area is excessively corroded floor to undersill (near fuel tank) (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded underwing (2.4.A.3)

Offside front brake binding (3.7.B.1)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

front brake application uneven (3.7.B.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Rear front brake fluctuating, but not excessively (3.7.B.3)

Suspension arms corroded

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement both (2.4.G.2)

Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement both (2.4.G.2)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Rear fog lamp not working (1.3.2b)

Nearside Front Ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Battery insecure (1.9.1)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Parking brake lever has no reserve travel (3.1.6b)

Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

due to lower front panel damage vehicle radiator insecure.

Exhaust has a major leak of exhaust gases (7.1.2)

Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Anti-roll bar linkage ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Parking brake lever has no reserve travel (3.1.6b)

Rear Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Rear Upper Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Rear fog lamp not working (1.3.2b)

Oil leak

some poor repairs to under body and generaly rusty

battery insecure

Exhaust system not adequately supported (7.1.1)

Front front brake application uneven (3.7.B.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Stop lamp not working (1.2.1b)

battery insecure

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Rear fog lamp insecure (1.3.2a)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Offside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Horn not working (1.6.2a)

Rear Rear fog lamp not working (1.3.2b)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)