1996 Rover Mini

Brake fluid level sensor wire broken.

Front Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Upper Suspension arm ball joint has slight play May require greasing. (5.3.4 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Small hole at rear of floor ns but not able to go through both layers of material. (6.1.1 (c) (i))

Os door hinge movement.

Rear Sub-frame corroded but not seriously weakened Subframe generally rusty. (5.3.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Windscreen washer not working (3.5 (a))

Nearside Front Seat belt buckle not functioning as intended (7.1.2 (d))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Engine mounting excessively loose Bolt missing in lower stabiliser at subframe. (6.1.8 (a) (ii)) DANGEROUS

Brake fluid level sensor wire broken.

Front Sub-frame pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Upper Suspension arm ball joint has slight play May require greasing. (5.3.4 (a) (i))

Integral body structure is corroded but structural rigidity is not significantly reduced Small hole at rear of floor ns but not able to go through both layers of material. (6.1.1 (c) (i))

Os door hinge movement.

Rear Sub-frame corroded but not seriously weakened Subframe generally rusty. (5.3.3 (b) (i))

Brake res switch wire broken.

Offside Driver's door hinge deteriorated but the door can still be readily opened and closed Hinge bolt loose. (6.2.3 (c) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake res switch wire broken.

Offside Driver's door hinge deteriorated but the door can still be readily opened and closed Hinge bolt loose. (6.2.3 (c) (i))

Brake fluid res wire not connected.

Screws loose in door os

Nearside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt Ball joint gaiter to damper. (5.3.4 (b) (ii))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Upper Suspension arm ball joint dust cover no longer prevents the ingress of dirt Ball joint gaiter to damper. (5.3.4 (b) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Brake fluid sensor wire not connected.

Nearside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint has slight play (5.3.4 (a) (i))

oil leak from ns drive shaft seal and gear selector shaft seal.

osf door upper hinge screws loose.

Tyre slightly damaged/cracking or perishing both rear (5.2.3 (d) (ii))

front suspension inner dust covers deteriorated

nearside front upper suspension ball joint slight play

offside front upper and lower suspension ball joints slight play

parking brake just to req efficiency

both front inner ball joint dust covers deteriorated

parking brake just to req efficiency ( offside lower effort)

slight play in both front upper outer ball joints

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

both front inner ball joint dust covers deteriorated

parking brake just to req efficiency ( offside lower effort)

slight play in both front upper outer ball joints

both front upper inner suspension dust cover deteriorated

parking brake just to req efficiency

rear fuel pipe perishing

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Nearside Front Tyre worn close to legal limit/worn on edge 1.6mm (5.2.3 (e))

both front upper inner suspension dust cover deteriorated

parking brake just to req efficiency

rear fuel pipe perishing

Offside Front Upper Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Front Body component insecure cooling fan (6.2.1 (a) (i))

Nearside Front Suspension rod pin or bush excessively worn (5.3.4 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Rear fog lamp missing (4.5.1 (a) (ii))

Centre Front slight blow from exhaust joint

Offside Front Front wheel bearing has slight play (2.5.A.3c)

both rear tyres perished.

Offside Steering rack gaiter split (2.2.D.2d)

both rear tyres perished.

Both nearside and offside front floor sections corroded.

Nearside Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Oil leak

Emissions not tested (7.0)

Nearside rear brake recording little or no effort (3.7.B.5a)

Service brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Windscreen wiper not operating automatically when switched on (8.2.1b)

Both nearside and offside front floor sections corroded.

Nearside Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Oil leak

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear brake recording little or no effort (3.7.B.5a)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Nearside Front Lower Ball joint has slight play (2.2.B.1f)

Nearside Front Upper Ball joint has slight play (2.2.B.1f)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Vehicle structure has slight corrosion (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Lower Ball joint has slight play (2.2.B.1f)

Nearside Front Upper Ball joint has slight play (2.2.B.1f)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Vehicle structure has slight corrosion (6.1.B.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Rear rear brake binding (3.7.B.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Nearside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Rear fog lamp flickers when tapped lightly by hand (1.1.6d)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Nearside Headlamp not working on main beam (1.7.5a)

Nearside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Outer Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)