1997 Ford Explorer

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced all chassis covered with surface rust (6.1.1 (c) (i))

Central Exhaust has a major leak of exhaust gases (6.1.2 (a))

Emissions unable to be completed excessively leaking (8.2.1.2 (d))

Horn not working (7.7 (a))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Vehicle structure is corroded but structural rigidity is not significantly reduced all chassis has surface corrosion (6.1.1 (c) (i))

Central Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Power steering pipe(s) or hose(s) has slight seepage from a seal (2.3.3b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush might need tightening (2.4.G.2)

Nearside Front Upper Suspension arm ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Headlamp aim too high (1.8)

Offside Headlamp aim too high (1.8)

Offside Headlamp insecure (1.7.3)

Front Brake pad(s) wearing thin (3.5.1g)

Front Brake pad(s) wearing thin (3.5.1g)

gearbox oil leak

rear suspension leveling link bar disconnected

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear position lamp(s) not working (1.1.A.3b)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.C.1b)

Rear Exhaust system not adequately supported new mount needing welding to exhaust (7.1.1)

Service brake: efficiency below requirements (3.7.C.1a)

Nearside Front Brake pipe excessively corroded (3.6.B.2c) DANGEROUS

Offside Front Brake pipe excessively corroded (3.6.B.2c) DANGEROUS

Rear Brake pipe excessively corroded main (3.6.B.2c) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Gearbox oil leak

Rear suspension leveling link bar disconnected

Front registration plate deteriorated but not likely to be misread (6.3.1d)

O/S/F & N/S/F Wipers worn.

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Waxoiled

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Offside Direction indicator not working (1.4.A.2c)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Rear Brake pad(s) wearing thin (3.5.1g)

engine man light on

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Windscreen has a sticker or other obstruction encroaching into the swept area by more than 40mm outside zone 'A' (8.3.1e)

Windscreen washer provides insufficient washer liquid (8.2.3)

Engine light on

Rattle from exhaust heat shields

Rear leaf spring bushes slightly worn

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Anti-roll bar linkage insecure (2.4.G.1)

Offside Rear Stop lamp not working (1.2.1b)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)