1996 MG Mgf

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

general underbody corrosion

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive sill (5.3.6 (a) (i))

general underbody corrosion

Front Windscreen wiper blade defective (3.4 (b) (i))

Nearside Rear Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Offside Rear Tyre not fitted in accordance with side wall instructions (5.2.3 (i))

Nearside Rear Suspension component ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength within 30cm off subframe mounting (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength within 30 off subframe mounting (5.3.6 (a) (i))

offside outer sill corroded

Brake performance not tested brake fluid leak (1.2.1 (g))

Brake pipe excessively corroded front to rear also insecure (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Track rod end seriously misaligned track rod end to steering arm lock nut insecure (2.1.3 (e))

Passenger compartment passenger compartment in such a condition that it permits the entry of exhaust fumes engine cover missing (6.2.1 (c) (i))

Brake pipe leaking on a hydraulic braking system rear connection union on t piece front to rear pipe. (1.1.11 (b) (ii)) DANGEROUS

Nearside Front Brake pad(s) incorrectly mounted (1.1.13 (c)) DANGEROUS

offside outer sill corroded

Nearside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Tie bar/rod has excessive play in a pin/bush CENTER BUSH (2.4.G.2)

Parking brake lever has no reserve travel (3.1.6b)

Rear Brake pipe excessively corroded BOTH REAR PIPES FROM FLEXI - PIPES MARKED (3.6.B.2c)

rear brake recording little or no effort (3.7.B.5a)

Anti-roll bar linkage has slight play in a pin/bush D BUSHES (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Body has slight corrosion JACKING POINT (6.1.B.2)

Nearside Rear Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Body has slight corrosion JACKING POINT (6.1.B.2)

Offside Front brake disc worn, pitted or scored, but not seriously weakened ON INNER FACE (3.5.1i)

Offside Rear brake disc worn, pitted or scored, but not seriously weakened ON INNER FACE (3.5.1i)

Oil leak ()

Rear Brake pad(s) wearing thin (3.5.1g)

CLUTCH SLAVE CYLINDER LEAKING

CLUTCH SLAVE CYLINDER PIPE HIGHLY CORRODED

Front Headlamp deteriorated but light output not reduced both sides (1.7.5a)

Front Sub-frame corroded but not seriously weakened (2.4.G.1)

Front Tyre worn close to the legal limit both sides & worn on inner shoulders (4.1.E.1)

Front Tyre worn close to the legal limit both sides & worn on inner shoulders (4.1.E.1)

Nearside Front Lower Suspension arm has slight play in a ball joint outer (2.4.G.2)

Nearside Rear Brake pipe slightly corroded to hose (3.6.B.2c)

Offside Front Lower Suspension arm has slight play in a ball joint outer (2.4.G.2)

Offside Rear Brake pipe slightly corroded to hose (3.6.B.2c)

Rear Direction indicator slightly discoloured both (1.4.A.2f)

Rear brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brakes imbalanced across an axle (3.7.B.5b)

front brake application uneven (3.7.B.2)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)