1997 Kawasaki ZX-7R

Drive chain slightly tight (6.1.7 (k) (i))

Front Headlamp light intensity reduced (4.1.4 (a))

Drive chain excessively tight (6.1.7 (k) (i))

Headlamp aim too low (4.1.2 (a))

Front Position lamp not working (4.2.1 (a))

Headlamp aim too low (4.1.2 (a))

Rear Direction indicator obviously incorrectly positioned Indicator spacing less than 180mm (4.4.3 (a))

Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Registration plate does not conform to the specified requirements (0.1 (d))

Handlebar grip insecure to handlebar Left & right grips insecure (2.2.1 (d) (ii)) DANGEROUS

Drive chain slightly loose (6.1.7 (c) (i))

Fuel cap rubber seal missing

advise, slight uneven wear to front tyre.

Steering control chaffing between components and not interfering with free movement of steering (2.1.2a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Steering control chaffing between components and not interfering with free movement of steering (2.1.2a)

Bike presented for test fitted with alloy front brake hose fittings - liable to corrosion in winter.

Bike presented for test with rear spring pe-load loosened to lower ride height.

Exhaust noisy (7.1.2)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Brake hose slightly twisted (3.2.B3a)

Front shock absorber has light misting of stanchion (2.3.3)

bike presented for test fitted with alloy front brake hose banjo fittings - liable to corrosion during winter. implications explained to customer.

rear shock absorber spring adjuster wound off - slightly loose when rear wheel raised off ground.

Front Brake hose is likely to be fouled or trapped by moving parts (3.2.B2c)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear reflector on sidecar missing (1.4.1)

Registration plate characters incorrectly spaced (6.3.4a)

Registration plate with character(s) which are not the correct height (6.3.4a)

Registration plate with character(s) which are not the correct width (6.3.4a)

Front Brake hose slightly twisted (3.2.B3a)

Front shock absorber has light misting of stanchion (2.3.3)

bike presented for test fitted with alloy front brake hose banjo fittings - liable to corrosion during winter. implications explained to customer.

rear shock absorber spring adjuster wound off - slightly loose when rear wheel raised off ground.