1997 Land Rover Discovery

Central Suspension arm pin or bush excessively worn axle top ball joint excessive worn (5.3.4 (a) (i))

Front Prop shaft securing bolt loose Bolts loose (6.1.7 (a) (i))

Front Registration plate does not conform to the specified requirements (0.1 (d))

Nearside Front Body has an unsafe modification Bumper end cap missing (6.2.1 (d) (i))

Nearside Front Direction indicator lens defective such that the emitted light is adversely affected (4.4.1 (b) (ii))

Nearside Front Side repeater missing (4.4.1 (a) (ii))

Nearside Rear Position lamp lens seriously defective (4.2.1 (b))

Nearside Rear Suspension arm pin or bush excessively worn trailing arm bush (5.3.4 (a) (i))

Offside Front Body has an unsafe modification no bumper end caps (6.2.1 (d) (i))

Offside Front Driver's door cannot be opened from outside the vehicle (6.2.3 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Oil leaking excessively from engine (8.4.1 (a) (i))

Offside Rear Anti-roll bar attachment bracket/mounting missing Attachment bracket missing (5.3.3 (a) (ii)) DANGEROUS

Rear Anti-roll bar missing (5.3.3 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Rear Seat belt buckle slightly damaged (7.1.2 (d))

Offside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Wheel bearing has slight play both sides (5.1.3 (a) (i))

Front hub seals leaking - both sides

Offside Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Steering box leaking oil (2.1.1 (e) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

General underbody corrosion

Nearside Front Hub seal slight leak

Offside Front Brake pipe corroded, covered in grease or other material Under bonnet (1.1.11 (c))

Offside Front Hub seal slight leak

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Offside Rear Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced (7.1.1 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Rear Brake pipe connection leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

General underbody corrosion

Nearside Front Hub seal slight leak

Offside Front Brake pipe corroded, covered in grease or other material Under bonnet (1.1.11 (c))

Offside Front Hub seal slight leak

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Passenger's seat cannot be secured in the upright position. (6.2.A.2)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Nearside Rear Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Lower Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Passenger's seat cannot be secured in the upright position. (6.2.A.2)

Offside Rear Suspension component mounting prescribed area is excessively corroded inner wheel arch (2.4.A.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Offside Front inner wing

Oil leak ()

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Trailing arm has slight play in a pin/bush (2.4.G.2)

Rear Upper Shock absorber has a slightly worn bush both shock absorbers top bushes (2.7.4)

corrosion around rear body mountings - both sides, strong advisory

oil leak

Body has slight corrosion (6.1.B.2)

Oil leak

Shock absorber has a slightly worn bush (2.7.4)

Track rod end ball joint dust cover deteriorated, but preventing the ingress of dirt (2.2.C.1c)

Centre Brake pipe slightly corroded (3.6.B.2c)

EXHAUST HEAVILY CORRODED

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear wheel bearing has slight play (2.6.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Centre Brake pipe slightly corroded (3.6.B.2c)

EXHAUST HEAVILY CORRODED

Nearside Rear Brake pipe inadequately clipped (3.6.B.1)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear wheel bearing has slight play (2.6.2)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front wheel bearing has excessive play (2.5.A.3c)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Service brake: efficiency below requirements (3.7.B.7)

Front wiper's don't auto park but it is possible to park them manualy

Offside Drag link end ball joint has excessive play (2.2.B.1f)

Offside Rear Anti-roll bar linkage insecure (2.4.G.1)

Front wiper's don't auto park but it is possible to park them manualy

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Headlamp aim too high (hotspot upper edge above the horizontal 0% line) (1.6.D1)

Front Panhard rod has excessive play in a pin/bush (2.4.G.2)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)