1996 Renault Master

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Nearside Front Body panel corroded and likely to cause injury outer wing (6.2.1 (a) (i))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced body (6.1.1 (c) (i))

Nearside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced step (6.1.1 (c) (i))

Nearside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner wheel arch (6.1.1 (c) (i))

Nearside Rear Vehicle structure is deformed and structural rigidity is significantly reduced outer rigger (6.1.1 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced step (6.1.1 (c) (i))

Offside Front Inner Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch body (6.1.1 (c) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced rear inner lower wheel arch (6.1.1 (c) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Outer Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced body (6.1.1 (c) (i))

Offside Rear Direction indicator not working (4.4.1 (a) (ii))

Offside Rear Vehicle structure is deformed and structural rigidity is significantly reduced outer rigger (6.1.1 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Brake load sensing valve seized (3.6.E.3)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Headlamp insecure (1.7.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings crossmember (6.1.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Nearside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Rear Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

axle bump stops missing

oil leak

Battery insecure (1.9.1)

Nearside Front Outer Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Front Upper Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front brake disc contaminated by oil (3.5.1h)

Nearside Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill (6.1.B.2)

Nearside Rear Body has a sharp edge caused by corrosion bumper (6.1.C.1)

Nearside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Upper Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Upper Vehicle structure has excessive damage seriously affecting its strength within 30cm of a towbar mounting (6.6.6)

Offside Front Upper Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Upper Front suspension has excessive movement at a tie bar joint (2.5.A.1c)

Offside Lower Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill (6.1.B.2)

Offside Rear Inner Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Upper Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Upper Vehicle structure has excessive damage seriously affecting its strength within 30cm of a towbar mounting (6.6.6)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings crossmember (6.1.B.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Front Direction indicator slightly discoloured (1.4.A.2f)

Offside Rear Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Rear registration plate deteriorated but not likely to be misread (6.3.1d)

axle bump stops missing

oil leak

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside rear brake binding (3.7.B.1)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front wheel bearing has excessive play (2.5.A.3c)

Offside Front wheel bearing rough when rotated (2.5.A.2)

Offside Stop lamp adversely affected by the operation of another lamp (1.2.1f)

Offside Upper Suspension arm rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Offside Steering rack gaiter insecure (2.2.D.2d)

Offside Stop lamp not working (1.2.1b)

Parking brake: efficiency below requirements (3.7.B.7)

nearside rear brake slightly binding

Nearside Front Direction indicator not working (1.4.A.2c)

Nearside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Upper Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front front brake binding (3.7.B.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear rear brake binding (3.7.B.1)

Brakes imbalanced across an axle (3.7.B.5b) DANGEROUS

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Centre Towbar retaining device insecure (6.6.3a)

Centre Vehicle structure excessively corroded within 30cm of towbar mounting (6.6.6)

Exhaust system not adequately supported (7.1.1)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Headlamp insecure (1.7.3)

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Battery insecure

Brake load sensing valve linkage seized (3.6.E.3)

Brake pedal has insufficient reserve movement (3.3.A.5)

Brake performance not tested (3.7.A.1)

Brake performance not tested (3.7.A.1)

Fuel cap/sealing device does not fasten securely maintaining the sealing arrangement (7.2.4b)

Horn not working (1.6.2a)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Rear Brake cable has wires broken and is significantly weakened (3.5.1b)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Front Steering component mounting prescribed area is excessively corroded (2.2.C.1h)

Offside Front brake disc excessively scored (3.5.1h)

Offside Headlamp aim not tested (1.8.A.1c)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Headlamp not working on main beam (1.7.5a)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Rear position lamp(s) incorrect colour (1.1.A.3e)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Steering rack gaiter insecure (2.2.D.2d)

Offside Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Suspension arm has excessive play in a ball joint (2.4.G.2)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe excessively corroded (3.6.B.2c)

Service brake: efficiency below requirements (3.7.B.7)

Towbar component excessively corroded (6.6.1)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Nail in offside front tyre

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear position lamp(s) incomplete (1.1.4a)

Nearside Side repeater incomplete (1.5.A1b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear position lamp(s) incomplete (1.1.4a)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Direction indicator incorrect colour (1.4.A.2f)

Indicator switch faulty (1.4.A.1)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Side repeater not working (1.4.A.2c)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Brake pipe excessively corroded (3.6.B.2c)

Rear Registration plate lamp not working (1.1.5c)

front brake application uneven (3.7.B.2)

Front Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Front brake disc slightly pitted (3.5.1h)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Non obligatory mirror damaged

Oil leak

play in steering rack