2004 Mazda Bongo

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner arch (5.3.6 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Outrigger (6.1.1 (c) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner arch (5.3.6 (a) (i))

Offside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Crossmember under radiator (6.1.1 (c) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced Outrigger (6.1.1 (c) (i))

Rear fog lamp not working (4.5.1 (a) (ii))

Central Exhaust has a major leak of exhaust gases Above axle (6.1.2 (a))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis near rear of suspension arm (5.3.6 (a) (i))

Nearside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Offside Rear Hub Seal Slightly Leaking

Oil leak, but not excessive (8.4.1 (a) (i))

Underneath vehicle in Rusty Condition

Offside Front Body component corroded and likely to cause injury Wing (6.2.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Bumper insecure (6.1.4 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Offside Rear Hub Seal Slightly Leaking

Oil leak, but not excessive (8.4.1 (a) (i))

Underneath vehicle in Rusty Condition

Both front bumper mountings corroded

Offside Front Wheel arch corroded

Under neath of vehicle rusty condition

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Rear Bumper insecure (6.1.4 (a) (i))

Nearside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner and Outer Sills Rusty and Holed (5.3.6 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Both Front Bumper Brackets Slightly Corroded

Generally Underneath vehicle in rusty condition

Offside Front Wheel Arch Corroded

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

offside front wing corroded

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive sill (7.1.1 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

offside front wing corroded

n/s centre inner sill corroded

o/s centre inner sill corroded

Brake pipe slightly corroded front to rear (3.6.B.2c)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded cross member (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded inner sill (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded outer sill holed x 2 (2.4.A.3)

Offside Headlamp excessively deteriorated so that the light output is severely reduced (1.7.5a)

Offside Rear Seat belt anchorage prescribed area is excessively corroded valance (5.2.6)

Brake pipe slightly corroded front to rear (3.6.B.2c)

Offside Front Tyre worn close to the legal limit inner edge (4.1.E.1)

Offside Rear Tyre worn close to the legal limit inner edge (4.1.E.1)

Offside Headlamp has a product on the light source so that the light output is severely reduced (1.7.5a)

Windscreen washer provides insufficient washer liquid (8.2.3)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

rear body heavily holed and corroded at both rear corners (not in prescribed area)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Front Shock absorber has a serious fluid leak (2.7.3)

Nearside Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Nearside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar linkage rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Offside Rear fog lamp insecure (1.3.2a)

Offside Rear fog lamp not working (1.3.2b)

Offside Headlamp aim too low (1.8)

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Rear fog lamp not working (1.3.2b)

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)