1997 Honda Civic

Front bumper insecure

Nearside Front Front constant velocity joint is slightly worn (2.5.C.1b)

Nearside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Power steering pipe(s) or hose(s) has slight seepage from a joint (2.3.3b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Upper Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

engine and trans mounts split/perished

pas pump noisy

rear brake pipes corroded

underside surface corrosion

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside front brake fluctuating, but not excessively (3.7.B.3)

Offside front brake fluctuating, but not excessively (3.7.B.3)

Brake pipe excessively corroded (3.6.B.2c)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Front registration plate with character(s) which are not the correct height (6.3.4a)

Front registration plate with character(s) which are not the correct width (6.3.4a)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Tyre has ply or cords exposed (4.1.D.1b)

Headlamp damaged but light output not reduced (1.7.5a)

Horn not working (1.6.2a)

Nearside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Headlamp not working on main beam (1.7.5a)

Rear Rear fog lamp not working (1.3.2b)

Exhaust noisy (7.1.4)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Track rod end ball joint has excessive play (2.2.B.1f)

Offside Front coil spring fractured (2.4.C.1a)

Exhaust noisy (7.1.4)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

difficult to fully inspect front to rear brakepipes due to floor coverings.

Nearside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Offside Front Suspension arm corroded but not seriously weakened (2.4.G.1)

Suspension weakened but no possibility of the body or a component fouling a road wheel (2.4.A.1b)

Vehicle structure has slight corrosion (6.1.A.1)

advise slight corrsion starting on all brake pipe ends just after plastic covers

coil spring corroded (2.4.C.1b)