2002 Mitsubishi Fto

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Nearside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Inner Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Headlamp has a product on the lens but not seriously reducing light output (4.1.4 (b))

Offside Front Inner Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Offside Front Inner Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Rear Inner Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Offside Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Headlamp lens slightly defective condensation (4.1.1 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Front Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Rear Rear fog lamp not working (4.5.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm inside edge (5.2.3 (e)) DANGEROUS

Nearside Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Rear Tyre tread depth below requirements of 1.6mm inside edge out of shape (5.2.3 (e)) DANGEROUS

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Front Brake pipe corroded, covered in grease or other material to rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Lower Shock absorbers has an excessively worn bush (5.3.2 (c))

Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Brake pipe corroded, covered in grease or other material all (1.1.11 (c))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

suspension corrosion all over

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Suspension component mounting prescribed area is excessively corroded chassis (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Suspension spring mounting prescribed area is excessively corroded inner wing (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Service brake: efficiency below requirements (3.7.B.7)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Rear position lamp(s) adversely affected by the operation of another lamp (1.1.A.3f)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Hole in offside front floor.

Nail in nearside rear tyre

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside rear brake fluctuating, but not excessively (3.7.B.3)

Oil leak

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Steering rack gaiter split (2.2.D.2d)

Hole in offside front floor.

Nail in nearside rear tyre

Nearside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside rear brake fluctuating, but not excessively (3.7.B.3)

Oil leak

1 bulb not working in centre stop lamp

Nearside front tyre wearing on inner edge

Parking brake needs adjustment

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Inner Stop lamp not working (1.2.1b)

Offside Rear fog lamp not working (1.3.2b)

1 bulb not working in centre stop lamp

Nearside front tyre wearing on inner edge

Parking brake needs adjustment

Nearside Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Stop lamp not working (1.2.1b)

corrosion to inner sills

nearside front tyre worn below 1.6mm on raised tread

rear suspention arm bushes starting to split

slight play in rear anti roll bar bushes

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

offside wiper blade split at end but still clears screen

Body damage nearside front.

Nearside Front Road wheel slightly damaged (4.2.A.1a)

Nearside headlamp aim on lower limit.

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Rear exhaust securing clamp missing