1997 Rover Mini

Front Brakes imbalanced across an axle Axle 1 (1.2.1 (b) (i))

Offside Engine mounting damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Windscreen washer not working (3.5 (a))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Upper Suspension component ball joint excessively worn (5.3.4 (a) (i))

Offside Front Upper Suspension component ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Sub-frame corroded and seriously weakened (5.3.3 (b) (i))

Windscreen washer not working (3.5 (a))

Rear rear subframe weakened by corrosion

exhaust front pipes in poor condition

Brake pivot has restricted free movement both quadrants (3.5.1k)

Emissions not tested major blow not allowing lambda to pass (7.3.A.1)

Exhaust has a major leak of exhaust gases front pipe and cat flanges (7.1.2)

Hazard warning lamps inoperative (1.4.B.1b)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Wheel nut(s) missing (4.2.A.1e)

Nearside Headlamp aim too far to the right (1.8)

Offside Headlamp aim too high (1.8)

Windscreen wiper does not clear the windscreen effectively both (8.2.2)

Rear rear subframe weakened by corrosion

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

a pannels corroded

both front frames corroded in both front inner wheel arches

both rear heel boards corroded

both rear inner wheel arches corroded

front valance corroded

fuel pipe damaged under car

rear subrame corroded

rear valance corroded

Driver's seat insecure (6.2.A.1)

Emissions not tested (7.0)

Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front All position lamps not working (1.1.A.3b)

Offside Rear All position lamps not working (1.1.A.3b)

Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Windscreen washer provides insufficient washer liquid (8.2.3)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

a pannels corroded both

both front frames corroded in both front inner wheel arches

both front inner suspension boots slight damage

both rear heel boards corroded

both rear inner wheel arches corroded

front valance corroded

fuel pipe damaged

rear subframe corroded

rear valance corroded

Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Tie bar/rod damaged but not seriously weakened (2.4.G.1)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both front a pannels corroded

both front suspension unit joints damaged

both outersills corrodede

both rear hell boards corroded

front sub frame bushes slight worn

rear subframe corroded

slight movement to front ball joints

Brake lever has restricted free movement (3.5.1k)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Brake cable has wires broken and is significantly weakened (3.5.1b)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Rear fog lamp not working (1.3.2b)

Registration plate lamp not working (1.1.C.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tie bar/rod damaged but not seriously weakened (2.4.G.1)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Front Suspension arm rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

both front a pannels corroded

both front suspension unit joints damaged

both outersills corrodede

both rear hell boards corroded

front sub frame bushes slight worn

rear subframe corroded

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

both front ball joints slight play

both outer sills corroded

rear subframe corroded

rear valance corroded

Exhaust system not adequately supported (7.1.1)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Rear fog lamp not working (1.3.2b)

Nearside Front Track rod end ball joint has slight play (2.2.B.1f)

both front ball joints slight play

both outer sills corroded

rear subframe corroded

rear valance corroded

Exhaust has a minor leak of exhaust gases (7.1.2)

Front wheel bearing has slight play (2.5.A.3c)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

fuel pipe damage

rear sub frame corroded

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

brake disc excessively pitted (3.5.1h)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front wheel bearing has slight play (2.5.A.3c)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

fuel pipe damage

rear sub frame corroded

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Headlamp aim too high (1.8)

Nearside Front Wheel stud(s) missing (4.2.A.1e)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Side repeater incorrect colour (1.4.A.2f)

rear brake application uneven (3.7.B.2)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

bothside sills becoming corroded

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

exhaust heverly pasted

rear sub frame corroded

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Rear fog lamp not working (1.3.2b)

Nearside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

exhaust heverly pasted

rear sub frame corroded

Both Front Seats Have Slight Movement In Mounting Brackets

Slight Play And Movement In Front Subframe Rear Mountings

Slight Play In Steering Rack

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Front registration plate insecure (6.3.1b)

Both Front Seats Have Slight Movement In Mounting Brackets

Slight Play And Movement In Front Subframe Rear Mountings

Slight Play In Steering Rack

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Nearside Side repeater not working (1.4.A.2c)

Steering component is not secure to the vehicle structure (2.2.B.1a)

Front Sub-frame attachment bracket/mounting modified and seriously weakened (2.4.A.2) DANGEROUS

Front Subframe mounting prescribed area is deliberately modified which significantly reduces the original strength (2.4.A.3) DANGEROUS

Wheel Arch Spats Missing But Wheels Do Not Protrude Excessively