1996 Nissan Almera

Nearside Rear Body or chassis has an unsatisfactory modification, seriously affecting its strength within 30cm of the body mountings Near rear top suspension mounting in wheel arch area (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Behind off side wheel arch near exhaust mounting (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Near rear top suspension mounting in wheel arch area (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Off side rear outer sill (6.1.B.2)

Registration plate lamp not working (1.1.C.1d)

Nearside Front Body has slight corrosion Car floor just behind n/s/f wheel arch (6.1.B.2)

Nearside front outer cv boot starting to split

Offside front track rod end has slight play

Rear brake pipes corroded from flexi hose to drum

Slight corrosion to boot floor

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

offside front tyre worn edges

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Shock absorber insecure (2.7.2b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

offside front tyre worn edges

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Suspension weakened allowing body or other component to foul a road wheel or would do so if laden (2.4.A.1b)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

slight corrosion to rear chassis

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Headlamp aim too low (1.8)

slight corrosion to rear chassis

Front Anti-roll bar linkage has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Body has a sharp edge caused by damage (6.1.C.1)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Rear Exhaust has part of the system slightly deteriorated (7.1.1a)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)