1996 Mazda MX-3

Exhaust emissions likely to be affected by an exhaust leak (8.2.1.1 (b))

Nearside Front Brake hose excessively chafed (1.1.12 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner wheel arch (5.3.6 (a) (i))

Nearside Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength wheel arch (5.3.6 (a) (i))

Power steering component leaking steering rack (2.1.5 (a))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Exhaust has a major leak of exhaust gases in half (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp reflector slightly defective (4.1.1 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Headlamp reflector slightly defective (4.1.1 (b) (i))

Offside Registration plate lamp insecure (4.7.1 (c) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair (1.2.1 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

various signs of under body corrosion

Nearside Front Brake hose excessively damaged (1.1.12 (b) (ii))

Offside Front Brake hose excessively damaged (1.1.12 (b) (ii))

Offside Rear Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected (5.3.6 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

various signs of under body corrosion

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Suspension component mounting prescribed area is excessively corroded both rear outer sil (2.4.A.3)

Offside Front Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Exhaust has a minor leak of exhaust gases (7.1.2)

Offside Front tyre worn on inner edge

Offside Front Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Rear Brake pipe excessively corroded all rear brake pipes corroded (3.6.B.2c)

Rear Brake pipe excessively corroded both front to rear (3.6.B.2c)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Registration plate lamp insecure both reg plate lamp holders missing (1.1.C.1c)

brake disc in such a condition that it is seriously weakened all (3.5.1i)

Offside Front Tyre worn close to the legal limit worn on inner edge (4.1.E.1)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Front brake disc excessively pitted (3.5.1h)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Centre Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)