1996 Nissan Almera

Horn sounds harsh or grating (1.6.2e)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front position lamp(s) insecure (1.1.A.3a)

Nearside Headlamp aim too high (1.8)

Nearside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Brake pipe excessively corroded (3.6.B.2c)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Headlamp aim too high (1.8)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside front brake binding (3.7.B.1)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front coil spring corroded (2.4.C.1b)

Offside Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Rear coil spring corroded (2.4.C.1b)

Offside front brake juddering slightly (3.7.A.2b)

Oil leak

Parking brake lever has little reserve travel (3.1.6b)

Power steering pipe(s) or hose(s) has slight seepage (2.3.3b)

front tyres scrubbing

Front Brake pad(s) wearing thin (3.5.1g)

Emissions not tested (7.0)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

oil pressure sensor leaking

power steering leak

Exhaust system not adequately supported (7.1.1)

Nearside Headlamp aim too low (1.8)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Headlamp aim too low (1.8)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front brake pads down to indicators advise new

oil pressure sensor leaking

power steering leak

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

cat convertor bracket partially broken

Exhaust mounting missing (7.1.1b)

Exhaust system not adequately supported (7.1.1)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Headlamp aim too high (1.8)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

nearside front tyre hase a piece of rubber missing from side wall

Front registration plate deteriorated (6.3.1d)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)