1997 Kia Pride LX

Brake pedal anti-slip provision worn smooth (3.3.A.1b)

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Headlamp aim too low (1.8)

Nearside Rear wheel bearing rough when rotated (2.6.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen has damage to the swept area in excess of a 40mm circle outside zone 'A' (8.3.1d)

Windscreen washer provides insufficient washer liquid (8.2.3)

Clutch slipping

Nearside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Nearside Rear wheel bearing has slight play (2.6.2)

Offside Rear position lamp(s) slightly affected by the operation of another lamp (1.1.A.3f)

Offside Rear wheel bearing has slight play (2.6.2)

Offside front floor pan corroded and holed but not with in 30cms of prescribed area/s.

Offside headlight lens damp

Vehicle structure very rusty

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Headlamp not in a clean condition but not affecting beam image (1.2.4a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Emissions not tested (7.0)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust has part of the system excessively deteriorated (7.1.1a)

Nearside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Headlamp not in a clean condition but not affecting beam image (1.2.4a)

Offside Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Exhaust system not adequately supported (7.1.1)

Nearside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front Headlamp not working on dipped beam (1.7.5a)

Offside Rear Rear wheel bearing has slight play (2.6.2)

off side front headlight has water in it which may affect pattern when working