1996 Rover Mini

Nearside Front Seat belt buckle slightly damaged (7.1.2 (d))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Lower Suspension arm ball joint dust cover missing (5.3.4 (b) (ii))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Front Seat belt buckle slightly damaged (7.1.2 (d))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Front Registration plate insecure (0.1 (a))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded Inner arch sill and step (2.4.A.3)

Nearside Rear Direction indicator not working (1.4.A.2c)

Nearside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Suspension component mounting prescribed area is excessively corroded Inner arch sill and step (2.4.A.3)

Rear Stop lamp adversely affected by the operation of another lamp Both dim (1.2.1f)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Rear Tyre tread depth below requirements of 1.6mm Both (4.1.E.1)

Body has slight corrosion (6.1.B.2)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Rear Rear position lamp(s) deteriorated, but still visible from a reasonable distance (1.1.A.3d)

Brakes imbalanced across an axle (3.7.B.5b)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Front wheel bearing has excessive play (2.5.A.3c)

Offside Rear Braking system leaking (3.6.A.1)

Parking brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

rear brake lights faded

Front Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Nearside Rear Rear position lamp(s) incorrect colour (1.1.A.3e)

Offside Headlamp aim too high (1.8)

Offside Rear Rear position lamp(s) incorrect colour (1.1.A.3e)

rear lights required led bulbs

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

front disks corroded

Nearside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Braking system leaking (3.6.A.1)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Headlamp aim too high (1.8)

Offside Registration plate lamp not working (1.1.5c)

Offside Side repeater not working (1.4.A.2c)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

BOTH FRONT BRAKE BACK PLATES SLIGHTLY INSECURE

Exhaust has a minor leak of exhaust gases (7.1.2)

NEARSIDE HEADLAMP AIM ON UPPER LIMIT

OFFSIDE REAR TYRE OUTER SIDEWALL SLIGHTLY PERISHED

SLIGHT MOVEMENT IN NEARSIDE REAR WHEEL BEARING

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Headlamp aim too high (1.8)

Offside Headlamp not in good working order adversely affecting beam image (1.2.4a)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)