1996 Honda CB250

Direction indicators flashing more than 120 times per minute (1.5.1c)

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition silencers missing (7.1.2)

Headlamp aim too high and too far to the right. (1.6)

Throttle operating incorrectly sticks when steering lock to right (6.2.1f)

Horn missing (1.7.1) DANGEROUS

Nearside Lower Front suspension assembly component loose yoke clamp bolt loose (2.3.1) DANGEROUS

Steering headbearing has excessive free play (2.2.2) DANGEROUS

Wheel alignment slightly misaligned. misaligned due to wide rear tyre (2.5.1)

Nearside chainguard missing

Brake pedal cannot be released smoothly (3.1.3d)

Drive chain excessively tight (6.2.1d)

Exhaust mounting does not fully support the exhaust system (7.1.1.c)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Nearside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Wheel alignment slightly misaligned. misaligned due to wide rear tyre (2.5.1)

Nearside chainguard missing

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front wheel bearings have slight free play (2.3.5b)

Tyre worn close to the legal limit (4.1.3(ii))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

slight flat spot headbearing

Front Roller brake test indicates a binding brake (3.3.A1a)

Handlebar deformed (2.1.1b)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Headlamp aim too low (1.6)

Headlamp insecure (1.2.3b)

Nearside Rear Footrest missing (6.2.1a)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear wheel bearings have excessive free play (2.4.A.2c)

Nearside Front Front shock absorber has light misting of stanchion (2.3.3)

Offside Front Front shock absorber has light misting of stanchion (2.3.3)

Slight pitting to nearside & offside front forks

Steering movement slightly 'notchy' (2.2.1b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear wheel bearings have slight free play (2.4.A.2c)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Nearside Handlebar handgrip not secure to handlebars. (2.1.1c)

Registration plate character(s) likely to be misread (6.3.4b)

Steering control fouling between components which interferes with the free movement of the steering (2.1.2a)

All position lamps slightly affected by the operation of another lamp (1.1.3b)

Front Roller brake test indicates a slightly juddering brake (3.3.A1b)