1997 Rover 414

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Body has a sharp edge caused by corrosion (6.1.C.1)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Power steering pump leaking from a failed component (2.3.3b)

Centre Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Trailing arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

os floor becoming corroded

Emissions not tested (7.0)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is inadequately repaired (2.4.A.3)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Power steering pump leaking from a failed seal (2.3.3b)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

os floor becoming corroded

Power steering component(s) has slight seepage from a component (2.3.3b)

front discs becoming worn

front floors becoming corroded

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Track rod end ball joint dust cover excessively deteriorated so that it no longer prevents the ingress of dirt (2.2.C.1c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Power steering component(s) has slight seepage from a component (2.3.3b)

front discs becoming worn

front floors becoming corroded

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pad(s) wearing thin (3.5.1g)

Vehicle structure has slight corrosion (6.1.A.1)

light perishing rear tyres

fuel filler pipe rusty

Child seat fitted not allowing full inspection of adult belt

Oil leak

corrosion nearside front floor

fluid low in brake master cyl

nearside rack boot perishing cracks

nearside rear wheel slight binding

offside front tyre worn inner edge

power steering pipes wet

Front brake disc slightly pitted (3.5.1h)

No bsau number on front and rear number plates

n/s/ rear suspension bush split

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Front brake disc slightly pitted (3.5.1h)

No bsau number on front and rear number plates

n/s/ rear suspension bush split

Front Brake pipe excessively corroded (3.6.B.2c)

Front brake disc excessively scored (3.5.1h)

Nearside Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Both number plates faded

Both rear tyres worn, perished and have nails in them

Damage to offside front wing

Exhaust system corroded

Plastic covers on sills and over brake pipes

Slight seepage from power steering pipes

damage to boot lid

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Front Brake pad(s) wearing thin (3.5.1g)

Front constant velocity joint gaiter deteriorated (2.5.C.1a)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside Rear Mechanical brake component has restricted free movement (3.5.1k)

Offside Headlamp aim too low (1.8)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Brake pipe slightly corroded (3.6.B.2c)

Nearside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Offside Headlamp not in good working order but not adversely affecting beam image (1.2.4a)

Brakes imbalanced across an axle (3.7.B.5b)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Lower Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)