1996 Fiat Hymer Motorhome

Front Coil spring corroded o/s +n/s (5.3.1 (b) (i))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Tyre slightly damaged/cracking or perishing o/s +n/s (5.2.3 (d) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Front Coil spring corroded o/s +n/s (5.3.1 (b) (i))

Front Inner Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Tyre slightly damaged/cracking or perishing o/s +n/s (5.2.3 (d) (ii))

Front Windscreen washer not working (3.5 (a))

Horn not working (7.7 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Power steering pipe/hose slightly corroded (2.1.5 (g) (i))

Rear Brake valve leaking load valve (1.1.7 (d) (i))

Nearside Rear Direction indicator lens defective which has no effect on emitted light (4.4.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 28% imbalance (1.2.1 (b) (i))

UNDERTRAYS FITTED

Battery insecure and likely to cause a short circuit (4.13 (a) (ii))

Electrical wiring insecure and connectors likely to become disconnected battery terminal insecure (4.11 (a) (ii))

Horn not working (7.7 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake excessively binding (1.2.1 (f))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Battery insecure and likely to fall from carrier terminals loose (4.13 (a) (ii))

Nearside Front Headlamp aim too high and too far to the right. (4.1.2 (a))

Nearside Front Windscreen washer not working (3.5 (a))

Offside Front Headlamp aim too high and too far to the right. (4.1.2 (a))

Offside Front Hydraulic brake calliper leaking (1.1.16 (b) (i))

Offside Front Windscreen washer not working (3.5 (a))

Offside Rear Service brake excessively binding (1.2.1 (f))

Rear brake pipes covered in grease can not be fully inspected

Offside Rear Service brake excessively binding 50 kgf (1.2.1 (f))

Nearside Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear brake pipes covered in grease can not be fully inspected

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. 27% (3.7.B.5b)

Front Suspension component mounting prescribed area is corroded but not considered excessive crossmember (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear wheel bearing has slight play (2.6.2)

Horn not working (1.6.2a)

Nearside Front Upper Brake hose seriously damaged (found during steering lock to lock check) (2.2.D.2b)

Horn not working (1.6.2a)

Nearside Front Upper Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)