1997 Land Rover Discovery

Brake pedal anti-slip provision missing (1.1.2 (c))

Emissions not tested due to blow exhaust (8.2.2.2 (e))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Lower Position lamp not working (4.2.1 (a))

Nearside Rear Lower Shock absorbers insecurely attached bushes worn (5.3.2 (a) (i))

Nearside Rear Tyre has a tear, caused by separation or partial failure of its structure outer wall (5.2.3 (d) (i))

Nearside Rear fog lamp not working (4.5.1 (a) (ii))

Nearside Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced (6.1.1 (c) (i))

Offside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Brake pad(s) contaminated oil leaking on to brake pads (1.1.13 (b))

Offside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Power steering inoperative (2.1.5 (c) (i))

Nearside Drag link end ball joint worn to the extent there is a serious risk of detachment (2.1.3 (b) (ii)) DANGEROUS

Nearside Front Integral body structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired body mount corroded and insecure (6.2.2 (d) (ii)) DANGEROUS

Nearside Rear Integral body structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired body mount area corroded and insecure (6.2.2 (d) (ii)) DANGEROUS

Offside Front Integral body structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired body mount corroded and insecure (6.2.2 (d) (ii)) DANGEROUS

Offside Rear Integral body structure or chassis has excessive corrosion to the extent that overall security or stability of the body is impaired body mount area corroded and insecure (6.2.2 (d) (ii)) DANGEROUS

Nearside Front inner wing supports corroded and insecure

Offside Front inner wing supports corroded and insecure

Offside Rear oil leaking from hub

Nearside Front Track rod end ball joint has slight play drag link end (2.2.B.1f)

the weld repair coated with sealant

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front registration plate delaminated (6.3.1d)

Nearside Front Body has excessive displacement which may lead to loss of vehicle control sill to body (6.1.B.1a)

Nearside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Nearside Rear Shock absorber has an excessively worn bush (2.7.4)

Offside Front Body has excessive displacement which may lead to loss of vehicle control sill to chassis (6.1.B.1a)

Offside Rear Anti-roll bar has excessive play in a ball joint (2.4.G.2)

Offside Rear Shock absorber has a serious fluid leak (2.7.3)

Parking brake lever has no reserve travel (3.1.6b)

Torque/reaction arm has excessive play in a pin/bush rear a frame ball joint (2.4.G.2)

Drag link end ball joint has excessive play (2.2.B.1f) DANGEROUS

Nearside Front Brake pipe slightly corroded on caliper (3.6.B.2c)

Offside Front Brake pipe slightly corroded on caliper (3.6.B.2c)

Offside Front Front suspension ball joint dust cover damaged, but preventing the ingress of dirt diff seal is wet (2.4.G.2)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

all underside of vehicle has been coated in underseal and seam sealer to conceal welds

Nearside Front Brake pipe excessively corroded (3.6.B.2c)

Nearside Front Brake pipe excessively corroded on caliper (3.6.B.2c)

Offside Front Body has a sharp edge caused by damage bumper end cap missing (6.1.C.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Brake pipe excessively corroded on caliper (3.6.B.2c)

Offside Front Headlamp aim beam image obviously incorrect headlamp full of condensation (1.8.A.1b)

Offside Rear Brake pad(s) less than 1.5 mm thick metal to metal (3.5.1g)

Service brake: efficiency below requirements (3.7.C.1a)

Statutory seat belt missing all rear anchor points missing (5.1.1)

Nearside Front Braking system leaking (3.6.A.1) DANGEROUS

Offside Front Braking system leaking (3.6.A.1) DANGEROUS

Offside Front Front suspension ball joint dust cover damaged, but preventing the ingress of dirt diff seal is wet (2.4.G.2)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

all underside of vehicle has been coated in underseal and seam sealer to conceal welds

Offside rear brake fluctuating, but not excessively (3.7.B.3)

Brake pipe excessively corroded (3.6.B.2c)

Headlamp aim too high (1.8)

Offside rear brake fluctuating, but not excessively (3.7.B.3)

Brake pipe excessively corroded (3.6.B.2c)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear Lower Shock absorber has an excessively worn bush (2.7.4)

Offside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim too high (1.8)

Nearside Rear brake disc contaminated by oil (3.5.1h)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Upper Shock absorber has an excessively worn bush (2.7.4)

Offside Rear Upper Shock absorber has an excessively worn bush (2.7.4)

Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear brake disc slightly pitted (3.5.1h)

Offside Rear brake disc slightly pitted (3.5.1h)

nearside front wheel bearing slight play.

offside rear seat belt stalk plastic surround damaged.

rear section of front to rear brake pipe starting to corrode.

Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)