1997 Jeep Wrangler

Offside Front Lower Suspension component ball joint has slight play (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Brake performance not tested vehicle non start (1.2.1 (g))

Emissions not tested unable to compleate test due to exhaust temp damaging probe (8.2.1.2 (d))

Brake performance not tested vehicle non start (1.2.1 (g))

Emissions not tested vehicle non start (8.2.1.2 (d))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.2.1 (a))

Nearside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Nearside Front Lower Suspension rod pin or bush excessively worn rear bush (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Headlamp not working on main beam (4.1.1 (a) (ii))

Nearside Rear Direction indicator incorrect colour (4.4.3 (a))

Nearside Rear Upper Suspension rod pin or bush excessively worn upper both bushes (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage insecurely attached (5.3.3 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Offside Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Position lamp not working (4.2.1 (a) (ii))

Offside Rear Direction indicator incorrect colour (4.4.3 (a))

Offside Rear Upper Suspension rod pin or bush excessively worn both bushes (5.3.4 (a) (i))

Rear fog lamp missing (4.5.1 (a) (ii))

Rear Prop shaft joint so worn it is likely to fail (6.1.7 (c) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Direction indicator slightly discoloured (4.4.3 (a))

Nearside Rear Lower Suspension rod pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Direction indicator slightly discoloured (4.4.3 (a))

Offside Front Shock absorbers has a slightly worn bush (5.3.2 (c))

Offside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))