1996 Mazda MX-5

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened both sides (1.1.14 (a) (ii))

Nearside Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Inner Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

parking brake lever has little reserve travel

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Nail in tyre ()

Oil leak, but not excessive (8.4.1 (a) (i))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Nail in tyre ()

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Shock absorber has a serious fluid leak (2.7.3)

Nearside Rear Outer Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Sill (6.1.B.2)

Nearside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Sill centre vehicle (6.1.B.2)

Offside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Sill/arch (6.1.B.2)

Offside Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings Centre vehicle sill (6.1.B.2)

Rear Registration plate lamp not working Both (1.1.C.1d)

Nearside Front Brake slightly binding

Offside Front Tyre worn on inner/outer edges

rear pads worn

Nearside Front Lower Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded sill to floor (5.2.6)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Seat belt damaged sufficient to significantly weakened the webbing (5.2.2a)

rear pads worn

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear coil spring broken (2.4.C.1a)

Offside Registration plate lamp not working (1.1.C.1d)

Offside Front Seat belt damaged but webbing not significantly weakened (5.2.2a)

1/ o/s/rear wheel arch corroed

2/ o/s/front tyre worn 3/ n/s/rear inner sill holed

Nearside Rear coil spring broken (2.4.C.1a)

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

1/ o/s/rear wheel arch corroed

2/ o/s/front tyre worn 3/ n/s/rear inner sill holed

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Registration plate lamp not working (1.1.C.1d)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)