1997 BMW Z3

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Central Exhaust has a minor leak of exhaust gases joint and crack in silencer end plate (6.1.2 (a))

Nearside Play in steering rack inner joint(s) ()

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Headlamp levelling device inoperative (4.1.5 (a))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Central Exhaust has a minor leak of exhaust gases joint and crack in silencer end plate (6.1.2 (a))

Nearside Play in steering rack inner joint(s) ()

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Service brake imbalanced across an axle (1.2.1 (b) (i))

Offside Front Inner Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Front Both front tyres worn inner edges

Front Both front tyres worn inner edges

Nearside Front Headlamp aim too low (1.8)

Offside Front Headlamp aim too low (1.8)

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.A.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Both front tyres wearing on inner shoulders

Both wing mirrors repaired with tape. Secure at time of test

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Both front tyres wearing on inner shoulders

Both wing mirrors repaired with tape. Secure at time of test

Nearside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Nearside Front Tyre worn close to the legal limit Worn uneven on inner edge (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit Inner edge (4.1.E.1)

Offside Front Suspension arm has slight play in a pin/bush (2.4.G.2)

Offside Front Tyre worn close to the legal limit Worn uneven on inner edge (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear position lamp(s) not working (1.1.A.3b)

Nearside Front Suspension arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Headlamp aim too low and too far to the right. (1.8)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Fuel pipe/s corroded

Play in steering rack inner joint(s)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

minor damage to nearside rear outer sill

Nearside Brake cable has wires broken and is significantly weakened (3.5.1b)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Ball joint has excessive play (2.2.B.1f)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Suspension arm has slight play in a ball joint (2.4.G.2)

both front tyres wearing on inner edges

exhaust bracket broken at front but exhaust still fully supported