1996 Honda Cbr

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Front Repairs made to fuel tank. Not leaking.

Drive chain worn but not considered excessive drive chain (6.2.1e)

Front shock absorber has light misting of stanchion l/hand (2.3.3)

Front shock absorber has light misting of stanchion r/hand (2.3.3)

Front wheel bearings are slightly rough front (2.3.5b)

Front wheel bearings are slightly rough rear (2.3.5b)

no mirrors fitted

none standard exhaust can fitted

some body panels not fitted correctly

Brake pad(s) contaminated by oil or grease front r/hand (3.2.A1k)

Brake pad(s) less than 1.5 mm thick rear pads (3.2.A1f(i))

Headlamp aim too high front (1.6)

Stop lamp does not illuminate immediately a brake applies rear (1.3.1a)

Tyre tread depth is below minimum requirements of 1.0mm front (4.1.3(ii))

Tyre tread depth is below minimum requirements of 1.0mm rear (4.1.3(ii))

Drive chain worn but not considered excessive has some slight tight spots (6.2.1e)

Front shock absorber has light misting of stanchion l/hand misting (2.3.3)

Front shock absorber has light misting of stanchion r/h misting (2.3.3)

Front wheel bearings are slightly rough front wheel bearing (2.3.5b)

Rear wheel bearings are slightly rough rear (2.4.A.2c)

no mirrors fitted

none standard exhaust can fitted

some body panels not fitted correctly

Front Floor brake test indicates a binding brake (3.3.C2c)

Headlamp aim too low (1.6)

Headlamp main beam affected by the operation of another lamp (1.2.2c)

Rear Brake disc(s) cracked (3.2.A1g)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Registration plate with character(s) which are not the correct height (6.3.4a)

Registration plate with character(s) which are not the correct width (6.3.4a)

Riders seat insecure (6.2.1a)

Steering control has Insufficient clearance at full lock affecting the riders grasp of handlebars (2.1.2b)

Nearside Front Front suspension assembly excessive wear or free play in a front suspension component (2.3.4)