1997 Honda CBR900

Brake reservoir hose fouling rear brake hose

Exhaust noisy (8.1.1 (a))

Front Brake binding but not excessively (1.2.1 (f))

Front Stop lamp not working (4.3.1 (a) (ii))

Headlamp aim too high (4.1.2 (a))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Exhaust noisy (8.1.1 (a))

Front Brake binding but not excessively (1.2.1 (f))

Exhaust is leaking but is not excessively noisey (7.1.1b)

slight oil leak from oil filter

Exhaust noisy (7.1.2)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Exhaust noisy (7.1.2)

Exhaust noisy (7.1.2)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Drive chain slightly loose (6.2.1d)

Exhaust noisy (7.1.2)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Rear Drive chain slightly loose (6.2.1d)

Front Headlamp aim too high (1.6)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Nearside Front Brake disc(s) cracked (3.2.A1g)

Offside Front Brake disc(s) cracked (3.2.A1g)

Rear Brake disc(s) cracked (3.2.A1g)

Registration plate with character(s) which are not the correct height (6.3.4a)

Exhaust noisy (7.1.2)

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Tyre valve stem damaged which could cause sudden tyre deflation (4.1.2c)

Front Throttle operating incorrectly (6.2.1f)

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Headlamp aim too low (1.6)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Tyre worn close to the legal limit (4.1.3(ii))

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Nearside Rear Direction indicators not working (1.5.1c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))