1996 Nissan Almera

Nearside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor pan (5.3.6 (a) (i))

Offside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material brake hose to front of car (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis rail (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Driver's view of the road through the swept area of the windscreen materially affected by an obstruction wipers not resetting correctly (3.1 (a) (ii))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor pan (5.3.6 (a) (i))

Offside Front Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Brake pipe corroded, covered in grease or other material brake hose to front of car (1.1.11 (c))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive chassis rail (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust has a minor leak of exhaust gases between rear box and middle pipe (6.1.2 (a))

Front wipers dont work when operating washers

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Outer Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security seal (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Exhaust has a minor leak of exhaust gases between rear box and middle pipe (6.1.2 (a))

Front wipers dont work when operating washers

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Rear Lower Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Rear Outer Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security seal (6.2.2 (d) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nail in offside rear tyre

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Front Sub-frame corroded but not seriously weakened and rear (5.3.3 (b) (i))

Nearside Front Brake pipe corroded, covered in grease or other material and offside front (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material and offside rear (1.1.11 (c))

Offside Rear Nail in tyre ()

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Oil leak ()

underside and sills showing signs of corrosion and repair

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

front anti-roll bar link bushes starting to crack open but are still in tact.

Rear Exhaust has a major leak of exhaust gases box (7.1.2)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Brake pipe slightly corroded (3.6.B.2c)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Nearside Rear Seat belt attachment fitting badly deteriorated (5.2.3)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Seat belt attachment fitting badly deteriorated (5.2.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Brake pipe slightly corroded (3.6.B.2c)

advise rear exhaust box in poor condition

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

n/s/ outer driveshaft boot cracking .

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Oil leak

n/s/ outer driveshaft boot cracking .

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Front Brake pad(s) wearing thin (3.5.1g)

both front wiper blade rubbers split

exhaust front bracket correded on exhaust cat

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Front Brake hose has insufficient room to move, resulting in fouling on any part (3.6.B.4a)

Offside Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Front Brake pad(s) wearing thin (3.5.1g)

both front wiper blade rubbers split

exhaust front bracket correded on exhaust cat

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Outer Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Seat belt anchorage prescribed area is excessively corroded (5.2.6)