2003 Ford Dorchester

Front Hydraulic leak, but not excessive (8.4.1 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Power steering component has slight seepage from a component (2.1.5 (a))

Offside Rear Inner Integral body structure is corroded but structural rigidity is not significantly reduced sill section (6.1.1 (c) (i))

Rear Drag link end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt Both sides (2.1.3 (g) (i))

Front Hydraulic leak, but not excessive (8.4.1 (a) (i))

Front Power steering component has slight seepage from a component (2.1.5 (a))

Offside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill corroded (6.1.1 (c) (i))

Offside Front Inner Tyre has ply or cords exposed edge (5.2.3 (d) (ii)) DANGEROUS

Front Hydraulic leak, but not excessive (8.4.1 (a) (i))

Front Power steering component has slight seepage from a component (2.1.5 (a))

Offside Rear Inner Vehicle structure is corroded but structural rigidity is not significantly reduced sill corroded (6.1.1 (c) (i))

Offside Power steering component has slight seepage from a component steering rack. (2.1.5 (a))

Offside Rear Integral body structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security inner sill slight corrosion. (6.2.2 (d) (i))

Power steering component has slight seepage from a component (2.1.5 (a))

Nearside Front Headlamp aim projected beam image is obviously incorrect no visable pattern (4.1.2 (c))

Nearside Rear Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Suspension arm ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced chassis holed at rear subframe mount (6.1.1 (c) (i))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Power steering component has slight seepage from a component (2.1.5 (a))

park brake travel high.

Central Exhaust mounting defective Rubber mounting perished and cracked (6.1.2 (a))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Parking brake lever has minimal reserve travel

Nearside Rear Tie bar/rod ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Side repeater slightly discoloured (1.4.A.2f)

Rear Brake pad(s) wearing thin (3.5.1g)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill (6.1.B.2)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Seat belt stitching slightly frayed (5.2.2b)

Offside Front Brake pad(s) wearing thin (3.5.1g)

n/s/f floor pan and chassis rail rusty

N/S/R seatbelt frayed.

Power steering fluid leak.

Rear exhaust joint rusty.

Travel on handbrake.

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Front Brake pad(s) wearing thin (3.5.1g)

Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear Tyre worn close to the legal limit (4.1.E.1)

All previous advice items still apply

Offside Headlamp aim too high when the centre of the headlamp is below 850mm from the ground (1.6.B2)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Front Tyre worn close to the legal limit (4.1.E.1)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

extensive welding modifications carried out to centre of vehicle

front wipers poor

rear tyres low on edges