2006 MG ZS

Brake pipe corroded, covered in grease or other material Both rear slightly corroded (1.1.11 (c))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Rear Exhaust system insecure Pipe broken (6.1.2 (a))

Brake pipe corroded, covered in grease or other material Both rear slightly corroded (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust has a major leak of exhaust gases middle section (6.1.2 (a))

Offside Obligatory mirror seriously damaged, affecting the rear view (3.3 (b) (ii))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (2.4.A.3)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Nearside Rear Trailing arm corroded but not seriously weakened (2.4.G.1)

Nearside Rear brake slight bind

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive floor (2.4.A.3)

Offside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Rear Inner Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Offside Rear Trailing arm corroded but not seriously weakened (2.4.G.1)

Offside mirror damaged, but still usable

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Emissions not tested due to exhaust damage (7.3.A.1)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear rear brake binding (3.7.B.1)

Offside Side repeater insecure (1.4.A.2b)

Rear Exhaust system not adequately supported back box (7.1.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Track rod end ball joint has excessive play (2.2.B.1f)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Battery insecure (1.9.1)

Nearside Headlamp aim too high (1.8)

Nearside Stop lamp not working (1.2.1b)

Offside Rear Brake pad(s) insecure (3.5.1g)

Bonnet retaining device ineffective (8.4.2)

Centre Rear Stop lamp not working (1.2.1b)

Nearside Headlamp aim too high (1.8)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

n/s/f tyre outer wall damaged(no cords showing )

srs lamp on

Front Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Horn not working (1.6.2a)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

srs lamp on

Nearside Front Suspension arm has excessive play in a pin/bush (2.4.G.2)

Horn not working (1.6.2a)

plastic wrapped around offside front wheel.

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp excessively damaged so that the light output is severely reduced (1.7.5a)