2006 Ktm 250EXC

Front Wheel alignment incorrect which adversely affects the handling (2.4 (a))

Headlamp aim too high (4.1.2 (a))

All position lamps not working (4.2.1 (a))

Headlamp aim not tested (4.1.2 (b))

Headlamp not working on dipped beam (4.1.1 (a) (ii))

Headlamp not working on main beam (4.1.1 (a) (ii))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements mounted close to horiziontal (0.1 (d))

Registration plate incorrect too small (0.1 (c))

Steering operation linkage fouling when handlebars turned from lock to lock both steering locks missing (2.1.4 (a))

Suspension arm ball joint excessively worn loser shock mounting (5.3.4 (a) (i))

Front Stop lamp does not illuminate by the operation of both brake controls no switch fitted (4.3.2 (a) (iii)) DANGEROUS

Rear Stop lamp does not illuminate by the operation of both brake controls (4.3.2 (a) (iii)) DANGEROUS

rear registration characters slightly smaller than prescribed,but not likely to be misread

Rear wheel bearings have slight free play (2.4.A.2c)

only used during daylight hours,and not used at times of seriously reduced visibility.

Rear wheel bearings have slight free play (2.4.A.2c)

Registration plate missing (6.3.1a)

only used during daylight hours,and not used at times of seriously reduced visibility.

Rear Rear wheel bearings have slight free play (2.4.A.2c)

due to lighting system being masked over , this machine must only be used during daylight hours only